Register
Climber with oxygen mask on Everest

Climber with oxygen mask on Everest

Everest · Guides

Supplementary oxygen

PlanningBy Harry Kikstra

Bottled oxygen on Everest: who uses it and from what height, how the constant-flow systems work, and the checks to make before you rely on one.

Most climbers use supplementary oxygen (‘O2’), carried in bottles and delivered through a face mask. Some feel that using O2 is ‘cheating’ as it makes the ascent easier; others regard it as standard protective equipment, like crampons or gloves. Only about 1.6% of all summits have been made without supplementary oxygen: the Himalayan Database lists 221 ascents by 188 people to the end of 2025, and spring 2026 added at least three more, by Bartek Ziemski, Kristin Harila and Marcelo Segovia. Climbers with oxygen were about twenty times more likely to reach the top. The death rate among no-O2 climbers is higher, even though most of them are far more experienced, so let that be a warning.

The decision is a personal one, but there are genetic factors to consider: research shows that most people could not survive a climb of Everest without additional O2. Most climbers start using it at about 7500 m24,606 ft, though some start lower to conserve energy for summit day.

In the Death Zone you can’t run around or wave your arms to keep warm: it costs too much energy and oxygen. One reason for using O2 is that it helps to keep your body warm, preventing frostbite. On the other hand, each system weighs at least 4 kg, not counting spare bottles, so you need extra energy (and oxygen) just to carry the kit, diminishing its net advantage.

The two systems

Climbers’ oxygen bottles are filled with almost 100% pure O2 (unlike scuba tanks, which hold compressed air at 21%). Note that breathing only pure oxygen could be harmful: the resulting drop in carbon dioxide can narrow your blood vessels, actually preventing oxygen from reaching your brain and heart, so the gas is always mixed with ambient or exhaled air to create a breathable oxygen-rich mixture.

Almost all expeditions use constant-flow systems: a bottle, a regulator that sets the flow, a hose and a mask. The bottles are usually Russian-made Poisk cylinders. The old Poisk regulators and masks are still around, but most operators now use newer regulators and masks from Summit Oxygen or TopOut, which waste less oxygen and give a more reliable flow reading.

A typical cylinder is pressurized to several hundred bar, made of Kevlar-reinforced metal to save weight, and 3 or 4 litres in volume. The regulator screws on top and controls the gas flow, measured in litres per minute (l/min), settable from 0 to 4 l/min in half- or one-litre steps; its display shows the pressure remaining. Many factors affect the flow and pressure display, including temperature changes and mechanical errors, so check regularly, and bring spare regulators per team as back-up.

The hose usually has a small flow indicator built in, useful because it’s often impossible to check the regulator itself, with its display behind you inside your backpack. The mask is held over your face with straps. It protects your face against frostbite, but also limits your view and can fog your goggles. Modern masks have a reservoir (a bag or a rigid chamber) that stores the oxygen flowing while you breathe out, so less of it is wasted.

Electronic pulse-dose systems, which release oxygen only as you breathe in, have been tried, but they depend on batteries that die in the cold and are rarely used. Whatever your team uses, practise with your own mask and regulator long before the summit push.

Checks before you rely on it

Whichever system you use, check that:

  • The bottles are from a reputable supplier, preferably direct from the factory. Some organizations re-fill their bottles to save costs, but the oxygen content and quality could be compromised, including ‘wet’ oxygen, which risks freezing and blocking the system.
  • You open the regulator fully before screwing it onto the bottle, and close it only when the oxygen is flowing through it. Some regulators have broken because of sudden high pressure when attached ‘closed’ to a pressurized bottle. It may sound like a waste of O2, but it’s only a few seconds’ worth, and it protects your system and therefore your life.
  • Long before you need oxygen, test how the regulator and mask work together. Read the pressure, let the oxygen flow at a fixed rate for several minutes, timed carefully, then check the remaining pressure and calculate the actual flow. Knowing whether your regulator under- or over-delivers means you can calculate your remaining O2 time better.
  • You have enough. Although using O2 can increase safety, if it runs out the sudden shock can be deadly, especially if you were using a high flow rate. Do not spend more time in the Death Zone than you have oxygen for.

Calculating remaining oxygen time

To find how much oxygen is in a bottle, multiply its volume in litres by its pressure in bar. A 4-litre bottle at 250 bar (‘full’) effectively holds 1000 litres of O2 at atmospheric pressure; at 200 bar it holds 800 litres, and so on. (Bottles may be factory-filled to 300 bar, but leakage and cold reduce this to about 250 bar by the time they are ready to use, and the gauge can be off by ±15%, always check.) Divide the litres by your flow rate in litres per minute to get minutes remaining. This sounds simple at sea level, but when the Death Zone leaves you with the brainpower of a child, you’ll be glad you worked it out beforehand:

Flow rate (l/min)Typical useFull 4-litre bottle lasts
0.5Sleeping or resting in high campsabout 33 hours
1Easy groundabout 16 h 40 min
2Normal climbing paceabout 8 h 20 min
3Comfortable climbingabout 5 h 35 min
4Short bursts, e.g. the steepest parts of the Hillary or Second Stepabout 4 h 10 min

Remember to turn the flow back down after a strenuous section. Temperature affects both the pressure and, unexpectedly, the regulator’s flow rate; the only truly accurate measure would be to weigh the bottle, which isn’t feasible, so monitor your gauge and manage your supply carefully. A higher flow rate means you feel better and climb faster, but you need more bottles, and carrying extra loads increases your oxygen need. Each climber must find the best balance.

How many bottles?

As a guideline, most people use at least 4–5 bottles per attempt:

  • One bottle covers a night at Camp 2 and a move to High Camp, where you can start a second bottle if need be.
  • A second bottle (perhaps partly used) stays in High Camp for emergency and descent.
  • Summit day: a maximum of three bottles, even if you have a personal sherpa to carry two of them for you. Fast climbers may be up and down in 10 hours, but reckon on up to 18 hours of oxygen time for safety: either 6 hours per bottle with 3 bottles (a flow of about 2 l/min) or 9 hours per bottle with 2 (about 1.5 l/min). Use only full bottles on summit day, if you started a bottle the evening before, simply move the regulator to a fresh one.

To save energy, many climbers start using O2 from the North Col (Tibet) or Camp 3 (Nepal), so they need at least one further bottle. Always mark your bottles clearly, with waterproof markers and stickers: this may prevent ‘accidental’ usage by other climbers, a growing problem on Everest.

If you feel really bad on a summit attempt, it’s better to give up early. That way you can rest, recover and may be able to try again, whereas if you’ve used too much precious oxygen, your bid is over.

In summary: the benefits of O2 are higher climbing speed and warmer body temperature; its drawbacks are its weight and your dependency, if the system breaks or runs out, the sudden change can get you in serious trouble. Without oxygen you might boast that you climbed Everest ‘fair’, but you might also have to accept the congratulations with frostbitten hands.

← Altitude effectsOther health issues →
I have not conquered Everest, it has merely tolerated me.
— Peter Habeler
More quotes →